Roevin Engineering is currently hiring CNC Set up/Operator in Pickering, ON.
If you have a passion working towards with 3-6 axis machines, please APPLY & submit your profile in word doc to Carora@reovin.ca
Setup and operate vertical, horizontal 3-6 axis CNC machining centers and CNC lathes.
Primary Duties & Responsibilities:
*Setup of machines through use of proper tools, and the most efficient technique. Align vises, fixtures with indicator to be parallel or square to a reference surface. Indicate position of the fixture and parts. Set axis to correct position by using the right numeric code. Load and unload the program.
*Participate in the update and maintenance of set up sheets for all parts through the work center.
*Operate machine with proper guarding in place, report any damaged guarding, tool holders, tools etc. Ensure guards are replaced after set up. Monitor oil levels of machine; keep machine and tools in condition.
*Check the first part and make sure that all the dimensions are within tolerance.
*Change and modify programs where applicable.
*Change tool length and diameter offsets, fixture and pallet offsets.
*Modify and grind cutting tools as required, and use proper feed and speed for maximum efficiency.
*Keep production running; debur and prep parts for loading, or clean parts to reload.
*Check parts, debur, tapping, counter boring and cleaning up tools holders from the previous setup.
*Prepare tools and fixtures for the next job, get new tools, use regrind tools as required. Make sure to plan ahead when special tools may be required.
*Follow Health and Safety Policies and practice safe work habits, industrial hygiene and good housekeeping around benches and machines.
*Identify opportunities for improvement via new tooling, set up reduction concepts and programming changes to improve cost and delivery
*Participate in root cause and corrective action identification for inferior quality parts.
*All other duties as assigned.
*Basic computer skills are an asset, Fanuc or Mazak control knowledge is a must
*Ability to use all the available measuring tools such as micrometer, dial gauges, deep micrometer, vernier, measuring block, and height gauges
*Ability to create layouts, read and interpret blue prints and drawings
*Full understanding of geometric tolerances
*Ability to identify wear of cutting tools (inserts, drills, end mills, boring bars, etc.)
*Ability to change and set cutting tools
*Attention to Detail
*Initiative and Results Focused
If you meet all the requirements above, please APPLY & submit your profile in word doc to Carora@reovin.ca